Adjusting Settings In The Quick Access Menu - HEIDENHAIN ND 7000 Operating Instructions Manual

Basic operation | Status bar
Operating
element
6.10.2

Adjusting settings in the quick access menu

With the quick access menu, you can adjust the following settings:
The availability of settings in the quick access menu depends on the
which user is logged in.
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
The Scaling factor by which the stored position is multiplied during execution
of an MDI block or program block
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Function
Quick access menu
Setting of the units for linear values and angular values,
configuration of a scaling factor; tapping opens the quick
access menu
Further information: "Adjusting settings in the quick
access menu", Page 83
Preset table
Display of the current preset; tapping opens the preset
table
"Creating a preset table", Page 149
Further information:
Tool table
Display of the current tool; tapping opens the tool table
Further information: "Creating a tool table", Page 147
Stopwatch
Time display with Start / Stop function in h:mm:ss format
Further information: "Stopwatch", Page 84
Calculator
Calculator with the most important mathematical functions
and speed calculator
Further information: "Calculator", Page 85
Feed rate
Display of the actual feed rate of the currently fastest axis
Auxiliary functions
Auxiliary functions in Manual operation mode, depending
on the configured application mode
Further information: "Additional functions in Manual
operation mode", Page 85
MDI block
For creating machining blocks in MDI mode
6
83