HEIDENHAIN ND 7000 Operating Instructions Manual page 256

15
15.6.9 <Axis name> (settings of the axis)
Path:
Further information:
Parameters
Axis name
Axis type
Encoder
Error compensation
Positioning window
Minimum dwell time in manual
positioning window
256
Settings ► Axes ► <Axis name>
In order to use functions such as the execution of blocks, the
configuration of the axes must comply with the requirements of the
respective application.
"Fundamentals of axis configuration", Page 251
Explanation
Selection of the axis name displayed in the position preview
XYZ
The axis name S is displayed in the selection list once
you have selected Spindle or Gear spindle under Axis
type.
Definition of the axis type
Settings:
Not defined
Linear axis
Spindle
Gear spindle
Default value: Linear axis
Configuration of the connected encoder
Further information: "Encoder", Page 257
Configuration of the linear error compensation LEC or segment-
ed linear error compensation SLEC
"Linear error compensation (LEC)",
Further information:
Page 261
Further information: "Segmented linear error compensation
(SLEC)", Page 262
Error compensation is only available if you have
configured a Linear encoder under Encoder model.
If an Angle encoder or Angle encoder as linear
encoder has been configured, error compensation is
disabled automatically.
Input of the scaling factor for the positioning aid in MDI mode
Setting range: 0.020 mm ... 2.000 mm
Default value: 0.100
The entered required amount of time the axis to be in the
positioning window so that the block will be completed
Setting range: 0 ms to 10000 ms
Default value: 0 ms
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Settings | Axes