HEIDENHAIN ND 7000 Operating Instructions Manual page 135

Setup | Single steps for setup
Creating a user and password
You can create new Operator users. You can use any characters for the user ID
and the password. These entries are case-sensitive.
Requirement:
It is not possible to create new OEM or Setup-type users.
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
An OEM or Setup user is logged in.
Tap Settings in the main menu
Tap User
Tap Add
Tap the User ID input field
The User ID is displayed for user selection, e.g. at the
login prompt.
The User ID cannot be changed once it has been
defined.
Enter the user ID
Confirm the entry with RET
Tap the Name input field
Enter the name of the new user
Confirm the entry with RET
Tap the Password input field
Enter the new password and repeat it
Confirm the entry with RET
You can show the contents of the password fields in
plain text and hide them again.
Use the ON/OFF sliding switch to show or hide
the contents
Tap OK
A message appears
Close the message with OK
The user is created with the basic data. The user can then
further edit the data himself later
8
135