HEIDENHAIN ND 7000 Operating Instructions Manual page 275

Settings | Service
15.7.14 Settings (OEM area)
Settings ► Service ► OEM area ► Settings
Path:
Parameters
Application
Override display
Keyboard theme
Program run
Text database
Messages
15.7.15 Program execution
Settings ► Service ► OEM area ► Settings ► Program run
Path:
Parameter
Automatic advance on reaching
upper spindle sleeve final
position
M functions
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Explanation
The type of application mode; a change becomes active after a
restart
Settings:
Milling
Turning
Radial drilling (software option)
Default value: Milling
Type of override display in Manual mode and MDI
Settings:
Percent: The override is displayed as a percentage of the set
maximum feed rate
Value: Override is displayed in mm/min
Default value: Percent
Selection of the keyboard layout
Settings:
Standard: Confirm the input with (Return)
TNC: entry confirmed with (Enter)
Default value: Standard
Modifying of the program execution
Further information: "Program execution", Page 275
Text database with message texts that are used for OEM-specif-
ic messages
Further information: "Text database", Page 276
Definition of OEM-specific messages
"Messages", Page 277
Further information:
Explanation
Automatic advance when executing hole patterns always occurs
when the upper spindle sleeve limit switch is reached
Settings: ON or OFF
Default value: OFF
For the configuration, see "Configuring M functions", Page 276
15
275