HEIDENHAIN ND 7000 Operating Instructions Manual page 106

7
Configuring the spindle axis
Depending on the configuration of the connected machine tool, you must
configure the inputs and outputs and further parameters of the spindle axis prior to
operation. If your machine tool uses a gear spindle, then you can also configure the
corresponding gear stages.
Further information:
106
Tap Settings in the main menu
Tap Axes
Tap S or, if applicable, Not defined
Tap Axis type
Select the Axis type:
Spindle
Gear spindle
To switch to the previous display, tap Back
If applicable, select the axis name S for the axis from the Axis
name drop-down list
Tap Outputs
Enter the parameters for the analog outputs used (refer to
Page 264)
To switch to the previous display, tap Back
Tap Inputs
Enter the parameters for the digital and analog inputs used
(refer to Page 265)
To switch to the previous display, tap Back
If, under Axis type, the Gear spindle option is selected, then
tap Gear stages
Tap Add
Tap the gear stages and enter the parameters for the gear
stages (refer to Page 266)
To switch to the previous display, tap Back
If, under Axis type, the Gear spindle option is selected,
then activate or deactivate Gear stage selection through an
external signal using the ON/OFF slider
Enter the corresponding values in the Start-up time for
upper spindle speed range and Start-up time for lower
spindle speed range fields
If, under Axis type, the Spindle option is selected, then
enter the corresponding values in the Break point of
characteristic curve for start-up times and Minimum
spindle speed fields
If applicable, enter the corresponding values in the Maximum
spindle speed for oriented spindle stop and Maximum
spindle speed for thread cutting fields
"Spindle axis S", Page 263
Commissioning | Steps for commissioning
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020