HEIDENHAIN ND 7000 Operating Instructions Manual page 243

Settings | Sensors
Sensors
15.3
This chapter describes settings for configuring the sensors.
15.3.1 Touch probe
Settings ► Sensors ► Touch probe
Path:
Parameters
Touch probe
Always use touch probe for
probing
Length
Diameter
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Explanation
Selection of the edge finder
Settings:
NONE
KT 130
Default value: NONE
Definition whether the edge finder should always be used for
probing
Setting range: ON or OFF
Default value: OFF
Length offset of the edge finder
Setting range: ≥ 0.0001
Default value: 0.0000
Diameter of the edge finder
Setting range: ≥ 0.0001
Default value for selection of KT 130: 6.0000
15
243