Figure 38: Example Workpiece - Programming A Bolt Hole Circle And A Row Of Holes - HEIDENHAIN ND 7000 Operating Instructions Manual

Quick Start | Programming a row of holes (programming)
9.10 Programming a row of holes (programming)
Precondition:
The row of holes is machined in Programming mode. You can reuse the program
in a potential small batch production run. You can take the values directly from the
dimensioned drawing and enter them in the input fields.
Figure 38: Example workpiece – programming a bolt hole circle and a row of holes
Calling up
9.10.1 Creating the program header
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
The PGM software option is active
Tap Programming in the main menu
The operating element belongs to a group.
Further information:
elements", Page 70
The user interface for programming is displayed
Tap Create new program in the program management
A dialog box is opened.
In the dialog select the storage location, e.g.
Internal/Programs in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Create
A new program containing the Program header start block is
created
In Name enter the name Example
Confirm the entry with RET
In Unit for linear values select the mm unit of measure
The program has been successfully created; you can then
begin with programming
"Selecting grouped operating
9
171