Figure 58: Example Of A Program In The Programming Operating Mode - HEIDENHAIN ND 7000 Operating Instructions Manual

Programming (software option) | Block types
When machining a rectangular pocket in MDI and Program Run modes of
operation, the following applies:
Approaching the starting position is at clearance height at rapid traverse
If a target depth was defined, positioning is at Clearance height at the end of
the machining operation
13.3 Creating a program
A program always consists of a program header and a sequence of blocks. You
can define various block types, edit the associated block parameters, and delete
individual blocks from the program.

Figure 58: Example of a program in the Programming operating mode

1 View bar
2 Block parameters
3 Toolbar
4 Program blocks
5 Program management
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
1 2
3
4
5
13
219