HEIDENHAIN ND 7000 Operating Instructions Manual page 214

13
13.2.2 Coordinate systems
To change a coordinate system, you can call presets from the preset table. The
coordinate system of the selected preset will then be used after the call.
Further information:
Preset block
Parameter
Preset number
13.2.3 Machine functions
You can call machine functions to machine the workpiece.
The available functions depend on the configuration of the connected machine
tool. The following blocks and parameters are available:
Block type
Spindle speed
Tool call
M function
Dwell time
214
"Defining presets", Page 178
Description
ID from the preset table
Optional: Selection from preset table
Parameter / Description
Rotational speed of the tool spindle
Number of the tool
Optional: Selection from tool table
Further information:
When a tool call is run, the spindle is automatically
stopped and the user is requested to load the corre-
sponding tool.
Number of the M function
Optional: Selection from function table
Time interval between machining steps
Programming (software option) | Block types
"Selecting a tool", Page 187
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020