HEIDENHAIN ND 7000 Operating Instructions Manual page 224

13
13.5.4 Saving a program under a new name
13.5.5 Saving a program automatically
13.5.6 Deleting a program
13.6 Editing program blocks
You can make later changes to any block of a program. To apply the changes to the
program, you need to save the program again after you have made the changes.
Editing program blocks
224
Tap Save program as in the program management
In the dialog select the storage location, e.g.
Internal/Programs, in which you want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Save as
The program is saved
The name of the program is displayed on the toolbar
Tap Save program automatically in the program
management
All changes to the program will be automatically saved
immediately
Tap Delete the program in the program management
Tap Delete selection
Tap OK to confirm deletion
The program is deleted
Tap Open program in the program management
Select the storage location in the dialog,
e.g. Internal/Programs
Tap the folder containing the file
Tap the file
Tap Open
The selected program is loaded
Tap the desired block
The parameters of the selected block are displayed
Edit the relevant parameters, depending on the block type
Confirm each entry with RET
Tap Save program in the program management
The edited program is saved
Programming (software option) | Managing programs
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020