HEIDENHAIN ND 7000 Operating Instructions Manual page 260

15
Parameters
Reference mark
Maximum traverse path
Nominal increment
Interpolation
Inversion of reference mark
pulses
Reference point displacement
260
Explanation
Definition of the type of reference mark
Settings:
None: There is no reference mark
One: The encoder has one reference mark
Coded: The encoder has distance-coded reference marks
Default value: One
For linear encoders with coded reference marks:
maximum traverse path for determining the absolute position
Setting range: 0.1 mm ... 10000.0 mm
Default value: 20.0
For angle encoders with coded reference marks:
maximum nominal increment for determining the absolute
position
Setting range: > 0° ... 360°
Default value: 10.0
For encoders with TTL interface:
Interpolation value of the encoders and integrated interpolation
for the evaluation of the coded reference marks.
Settings:
None
2-fold
5-fold
10-fold
20-fold
50-fold
Default value: None
Specifies whether the reference mark pulses are evaluated in
inverted form
Settings
ON: Reference pulses are evaluated in inverted form
OFF: Reference pulses are not evaluated in inverted form
Default value: OFF
Configuration of the offset between the reference mark and the
zero point
Further information: "Reference point displacement",
Page 261
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Settings | Axes