Figure 39: Example Workpiece: Simulation Window; Figure 40: Example Workpiece - Drilling A Row Of Holes - HEIDENHAIN ND 7000 Operating Instructions Manual

Quick Start | Programming a row of holes (programming)
9.10.4 Simulating program run
After you have successfully programmed the bolt hole circle and row of holes, you
can simulate how the program will run by means of the simulation window.

Figure 39: Example workpiece: simulation window

9.11 Machining a row of holes (program run)
You have defined the individual machining steps for the row of holes in a program.
You can execute the created program in Program run.
Figure 40: Example workpiece – drilling a row of holes
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Tap Simulation window
The simulation window is displayed
Tap each program block, one after the other
The tapped machining step is shown in color in the
simulation window
Check the view for programming errors, e.g. tool path
intersections of holes
If there are no programming errors you can machine the bolt
hole circle and row of holes
9
173