HEIDENHAIN ND 7000 Operating Instructions Manual page 263

Settings | Axes
15.6.16 Spindle axis S
The switching functions are available only for units with ID number
1089179-xx.
Settings ► Axes ► Spindle axis S
Path:
Parameters
Axis name
Axis type
Outputs
Inputs
Gear stages
Gear stage selection through an
external signal
Start-up time for upper spindle
speed range
Start-up time for lower spindle
speed range
Break point of characteristic
curve for start-up times
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Explanation
Definition of the axis name displayed in the position preview
Settings:
Not defined
S
Default setting: S
Definition of the axis type
Settings:
Not defined
Linear axis
Spindle
Gear spindle
Default setting: Spindle
Configuration of the Outputs for the spindle
Further information: "Outputs (S)", Page 264
Configuration of the Inputs for the spindle
Further information: "Inputs (S)", Page 265
Configuration of the Gear stages for the Gear spindle
Further information: "Gear stages", Page 266
Selection of the Gear stages of the Gear spindle via external
signals
Settings
ON: Selection of the Gear stages is performed via external
signals
OFF: Selection of the Gear stages is performed manually in
the operating modes
Default value: OFF
Definition of the required Start-up time until Smax is reached
Setting range: 50 ms ... 10000 ms
Default value: 500
Definition of the required Start-up time until Smax is reached
Setting range: 50 ms ... 10000 ms
Default value: 500
Setting of the spindle speed that marks the transition from the
upper to the lower spindle speed range
Setting range: 0 rpm ... 2000 rpm
Default value: 1500
15
263