HEIDENHAIN ND 7000 Operating Instructions Manual page 168

9
Quick Start | Determining the preset (manual operation mode)
Probing preset D2
On the machine tool, insert the HEIDENHAIN KT 130 Edge
Finder into spindle and connect to the product
Further information: "Configuring a touch probe", Page 100
Tap Auxiliary functions in the status bar
Tap Find circle center in the dialog
The Select the tool dialog opens
In the Select the tool dialog, activate the Using touch-
probes option
Follow the instructions of the wizard
Move the edge finder toward the workpiece edge until the
red LED on the edge finder lights up
The Select preset dialog opens
Retract the edge finder from the workpiece edge
In the Selected preset field, select preset 1
In the Set position values field, enter the value 0 for position
value X and position value Y and confirm with RET
Tap Confirm in the wizard
The probed coordinates are loaded in preset 1
168
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020