HEIDENHAIN ND 7000 Operating Instructions Manual page 285

Servicing and maintenance | Restore user files
Restore user files
16.7
Backed-up user files of the product can be loaded into the product again. Existing
user files will be overwritten. This, together with the restoring of the settings,
enables you to restore the complete configuration of a unit.
Further information:
If servicing becomes necessary, a replacement unit can be operated with the
configuration of the failed unit after restoring. This requires that the version of
the old firmware matches that of the new firmware or that the versions are
compatible.
All files from all user groups that are stored in the respective folders are
backed up and can be restored as user files.
The files in the System folder are not restored.
Safely removing a USB mass storage device
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
"Restore settings", Page 284
Tap Settings in the main menu
Open in the sequence
Tap Service
Open in the sequence
Back up and restore
Restore user files
Tap Load as ZIP
If required, connect a USB mass storage device (FAT32
format) to a USB port of the product
Navigate to the folder containing the backup file
Select the backup file
Tap Select
Confirm the successful transfer with OK
To restart the product with the transferred user files, switch
the product off and then back on
Tap File management in the main menu
Navigate to the list of storage locations
Tap Safely remove
The message The storage medium can be removed now.
appears
Disconnect the USB mass storage device
16
285