Overview; Assembly Of The Product; Figure 1: Dimensions Of Rear Panel Of The Product - HEIDENHAIN ND 7000 Operating Instructions Manual

4
4.1

Overview

This chapter describes the mounting of the product. It contains instructions about
how to correctly mount the product on stands or holders.
4.2

Assembly of the product

General mounting information
The mount for the mounting variants is provided on the rear panel. The mounting
hole pattern corresponds to a grid of 50 mm x 50 mm.

Figure 1: Dimensions of rear panel of the product

The materials for attachment of the mounting variants on the device are included in
delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Allen key, size 2.5 (Duo-Pos stand)
Materials for mounting on a supporting surface
40
The following steps must be performed only by qualified personnel.
"Personnel qualification", Page 29
Further information:
The unit must be mounted to a stand or a holder to ensure the correct
and intended use of the product.
50
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Mounting | Overview