Connecting A Printer; Connecting Input Devices - HEIDENHAIN ND 7000 Operating Instructions Manual

Installation | Connecting a printer
5.7

Connecting a printer

Connecting a USB printer
Comply with the pin layout
Remove and save the dust protection cap
Route the cables based on the mounting variant
Further information:
Connect USB printer to USB Type-A port (X32). Make sure the USB cable
connector is fully inserted
Further information:
Pin layout X32
3 2 1
4
1
DC 5 V
Connecting an Ethernet printer
Comply with the pin layout
Remove and save the dust protection cap
Route the cables based on the mounting variant
Further information:
Connect the Ethernet printer to the Ethernet port X116 using a standard CAT.5
cable. The cable connector must firmly engage in the port
Further information:
Pin layout of X116
1 2 3 4 5 6 7 8
1
D1+ D1-
(TX+) (TX-)
5.8

Connecting input devices

Comply with the pin layout
Remove and save the dust protection cap
Route the cables based on the mounting variant
Further information:
Connect USB mouse or USB keyboard to USB Type-A port (X32). Make sure the
USB cable connector is fully inserted
Further information:
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
"Assembly of the product", Page 40
"Device overview", Page 47
2
Data (–)
"Assembly of the product", Page 40
"Device overview", Page 47
2 3 4
D2+ D3+
(RX+)
"Assembly of the product", Page 40
"Device overview", Page 47
3
Data (+)
5 6 7
D3– D2– D4+
(RX–)
4
GND
8
D4–
5
55