HEIDENHAIN ND 7000 Operating Instructions Manual page 138

8
Configuring the network
Network settings
Requirement:
Further information:
Further information:
138
Contact your network administrator for the correct network settings for
configuring the product.
The unit is connected to a network.
"Connecting a network peripheral", Page 56
Tap Settings in the main menu
Tap Interfaces
Tap Network
Tap the X116 interface
The MAC address is detected automatically
Depending on the network environment, use the ON/OFF
slider to activate or deactivate the DHCP function
If DHCP is active, the network settings are obtained
automatically as soon as the IP address is assigned
If DHCP is not active, enter the IPv4 address, IPv4 subnet
mask and IPv4 standard gateway
Confirm the entries with RET
Depending on the network environment, use the ON/OFF
slider to activate or deactivate the IPv6 SLAAC function
If IPv6 SLAAC is active, the network settings are obtained
automatically as soon as the IP address is assigned
If IPv6 SLAAC is not active, enter the IPv6 address, IPv6
subnet prefix length and IPv6 standard gateway
Confirm the entires with RET
Enter the Preferred DNS server and, if required, the
Alternative DNS server
Confirm the entires with RET
The configuration of the network connection is applied
"Network", Page 244
Setup | Single steps for setup
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020