Table of Contents
Advertisement
RH8100 V3 Server
User Guide
The following OSs support the hot swap feature of a PCIe card by default:
●
●
●
RHEL 6.9 supports hot swap of HBAs (BOM: 06030217) and 82599 NICs (BOM:
02311DVM).
SUSE Linux Enterprise Server 11 SP3 does not support the hot swap feature of a
PCIe card by default. To enable SUSE Linux Enterprise Server 11 SP3 to support
this feature, run the modprobe pciehp command to load the hot swap driver. You
can run the modinfo pciehp command to view the hot swap driver.
Other OSs do not support the hot swap feature of a PCIe card.
Before you hot-swap a Qlogic card on Windows, uninstall the Qlogic card
management software, including:
Management Agents, QConvergeConsole CLI Management Tool, and
QConvergeConsole GUI Management Tool
Otherwise, after you press the hot swap button, the Qlogic card cannot be
powered off because the Qlogic card driver is used by the management software.
Data
●
●
●
Tools
●
●
Hardware
Spare PCIe card
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see
Step 2 Take the spare PCIe card out of its ESD bag.
Step 3 Check whether the PCIe card is the one shipped with the RH8100 V3.
●
●
Step 4 Insert the PCIe card into the slot. See
Issue 30 (2019-12-19)
Windows Server 2008 R2
Windows Server 2012
Red Hat Enterprise Linux 6.4
NO TICE
You have obtained the cabinet number and chassis number of the RH8100 V3.
You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
You have determined the position on the RH8100 V3 for installing a PCIe card.
ESD gloves
Packaging materials, for example, an ESD bag
If yes, go to
Step
6.
If no, go to
Step
4.
Copyright © Huawei Technologies Co., Ltd.
5 Removing and Installing Parts of the RH8100 V3
Figure 5-156
or
Figure
1 Safety
Instructions.
5-157.
289
Advertisement
Table of Contents
