Huawei RH8100 V3 User Manual page 253

RH8100 V3 Server
User Guide
If cables are not connected as
reports alarm 1B01FFFF. Reconnect the cables to clear the alarm.
Prerequisites
Conditions
●
●
●
Data
●
●
●
Tools
●
●
●
Hardware
Spare RAID controller card
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see
Step 2 Take the spare RAID controller card out of its ESD bag.
Step 3 Align the connector on the RAID controller card with the port on the mainboard,
and insert the RAID controller card slowly into the mainboard. See step (1) in
Figure
Step 4 Tighten the screws on the RAID controller card. See step (2) in
Issue 30 (2019-12-19)
You have powered off the RH8100 V3. For details, see
RH8100 V3. Then you have removed all power cables from the server.
You have removed the front I/O module from the RH8100 V3. For details, see
5.8.1 Removing the Front I/O
You have removed the supercapacitor tray. For details, see
Supercapacitor.
You have obtained the cabinet number and chassis number of the RH8100 V3.
You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
You have determined the position on the RH8100 V3 for installing a RAID
controller card.
ESD gloves
M3 Phillips screwdriver
Packaging materials, for example, an ESD bag
5-122.
Copyright © Huawei Technologies Co., Ltd.
5 Removing and Installing Parts of the RH8100 V3
Figure 5-120 or Figure 5-121
Module.
shows, a server
6.2 Powering Off the
5.8.9 Removing a
1 Safety Instructions.
Figure 5-122.
243