Removing A Raid Controller Card - Huawei RH8100 V3 User Manual

RH8100 V3 Server
User Guide
Prerequisites
Conditions
No special conditions are required for this operation.
Data
●
●
●
Tools
●
●
Hardware
Spare hard disk
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see
Step 2 Take the spare hard disk out of its ESD bag.
Step 3 Fully open the ejector lever and push the hard disk into the hard disk enclosure
along the guide rails until the hard disk is in place. See (1) in
Figure 5-96 Installing a hard disk
Step 4 Ensure that the ejector lever is engaged with the left partition board in the front
I/O module, and close the ejector lever to completely insert the hard disk into the
front I/O module. See step (2) in
----End

5.7.5 Removing a RAID Controller Card

This topic describes how to remove a RAID controller card.
Scenarios
Remove a RAID controller card if:
Issue 30 (2019-12-19)
You have obtained the cabinet number and chassis number of the RH8100 V3.
You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
You have determined the position on the RH8100 V3 for installing a hard disk.
ESD gloves
Packaging materials, for example, an ESD bag
Copyright © Huawei Technologies Co., Ltd.
5 Removing and Installing Parts of the RH8100 V3
Figure 5-96.
1 Safety Instructions.
Figure 5-96.
213