Huawei RH8100 V3 User Manual page 104

RH8100 V3 Server
User Guide
Step 2 Number the new network cable.
●
●
Step 3 Route the new network cable.
Route the new network cable in the same way (underfloor or overhead) as the
network cable to be replaced. Note the following points:
●
●
●
●
Step 4 Remove the network cable to be replaced.
Remove the network cable from the network interface card (NIC) or board in a
cabinet.
Step 5 Connect the new network cable.
Only the management network port on HFC-2 can be used.
Take the following precautions when connecting the new network cable:
●
●
Issue 30 (2019-12-19)
The new network cable must have the same number as the one to be
replaced.
Use the same type of label for network cables. Record the name and number
of the local device to be connected on one side of the network cable, and
those of the peer device on the other side. Attach a label to the position 2 cm
(0.79 in.) away from the end of a network cable.
Underfloor cabling is recommended because it is tidy and easy to route. Route
cables in the cabinet based on the installation requirements. You are advised
to arrange new cables in the same way as existing cables. Ensure that cables
are routed neatly and undamaged.
Separate network cables from power cables for routing.
Bend a network cable with the bending radius of no less than 4 cm (1.57 in.)
to prevent damage to core wires. Check that the cable insulation layer is
intact. Ensure that cables are routed for easy maintenance and capacity
expansion.
Network cables must be bound using cable ties to ensure proper routing.
Check that network cables are bound together neatly and properly, are routed
straightly and close to each other. Cable ties must be installed at an even
spacing and fastened properly.
NO TICE
Connect the new network cable to the same network port as the removed
one.
Connect the network cable to the network port securely.
Connect the RJ45 connector on the network cable to the network port on the
server. See Figure 3-12.
Copyright © Huawei Technologies Co., Ltd.
3 Installing the RH8100 V3
94