Tape Drive: Lock To Spe A (High/Critical Reliability Only); Tape Drive: Power Down Spe B; Remove The Un332B And Tape Drive - Avaya DEFINITY Server R Manual

Upgrading G3rV4 and R5/6/7/8r to Avaya DEFINITY
Server R running Avaya Communication Manager
6. Type status spe and press
For high or critical reliability systems:
The standby refreshes after 5 minutes. If the fields display something other
than the above, see the appropriate maintenance sections.
Tape Drive: Lock to SPE A
(High/Critical reliability only)
!
CAUTION:
Always wear a grounded wrist strap to ground yourself against electrostatic
discharge (ESD).
1. Move the SPE-SELECT switches to the left (SPE A) on both Duplication
Interface (DUPINT) circuit packs, one at a time.

Tape Drive: Power Down SPE B

!
CAUTION:
Do not power down the whole cabinet; it is not necessary.
NOTE:
If there are two power supplies, power down the SPE by removing the
power plug on the left side of the carrier then by removing the power plug on
the right side of the carrier. If there is only one power supply, remove the one
power plug on the right side.
For standard reliability, power down the SPE. This causes a service interruption.
For high or critical reliability, power down SPE B only.

Remove the UN332B and Tape Drive

1. Remove the blank faceplate next to the MSSNET slot in the SPE B carrier.
2. Remove the UN332/B circuit pack from the SPE B carrier and place it in
antistatic packing material.
3. Remove the tape from the tape drive (TN1656).
4. Remove the tape drive from the SPE B carrier and place it in antistatic
packing material.
2-24
Issue 7 November 2003
Enter
The Standby Refreshed field shows yes
The Standby Shadowing field shows on
The Standby Handshake field shows up
to check the health of the SPE.
555-233-115