Avaya DEFINITY Server R Manual page 464

Adding or Removing Cabinet Hardware
Installing the TN2302AP IP Media Processor
To install a TN2302AP IP Media Processor, you must install
One or more TN2302AP circuit pack
One or more TN799B/C circuit pack (A TN799B/C can support more than
one TN2302AP)
An IP Media Processor adapter.
Connect the cables for TN799B/C
1. Determine into which port slots you are putting the TN799B/C C-LAN
circuit packs.
From the rear of the cabinet:
2. Connect a 259A connector to the backplane connector corresponding to
each TN799B/C slot.
3. Connect one end of each DW8 cable to each 259A connector.
Connect the cables for TN2302AP
1. Determine into which port slots you are putting the TN2302AP IP Media
Processor circuit packs.
From the rear of the cabinet:
2. Connect the amphenol connector on the adapter to the backplane
connector corresponding to each TN2302AP slot.
Connect the Ethernet
1. Connect the network cable(s) to the ETHERNET connector on the
TN2302AP Amphenol adapter(s).
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
Install the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B/C and TN2302AP circuit packs are hot-swappable, so you do
not need to power down the carrier or cabinet to install them.
If replacing the existing TN799 circuit pack, remove it first and replace it with
the new TN799B/C.
7-54
Issue 7 November 2003 555-233-115