Avaya DEFINITY Server R Manual page 470

Adding or Removing Cabinet Hardware
4. Disconnect the modem's RS232 port from the H600-512 external cable
assembly.
From the rear of the cabinet:
5. Disconnect the amphenol connector on the existing external cable
assembly from the backplane connector corresponding to the TN802 circuit
pack.
6. Connect the amphenol connector of the TN2302AP Amphenol adapter to
the backplane connector corresponding to the slot selected for the
TN2302AP circuit pack.
NOTE:
The TN802 occupied 3 slots, and the cable was connected to the
rightmost backplane slot. For convenience use the same rightmost
slot vacated by the TN802 circuit pack for the TN2302AP circuit pack.
7. Connect the network cable to the Ethernet connector on the TN2302AP
Amphenol adapter.
Install the circuit packs
1. If replacing the TN799 circuit pack, install the TN799B/C circuit pack in the
slot vacated by the TN799 circuit pack.
2. For convenience install the TN2302AP circuit pack in the rightmost slot
vacated by the TN802 and where the adapter is connected to the
corresponding backplane connector. The other 2 slots are now available for
other circuit packs.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to
boot. The RED LED stays on until an IP address is assigned to the circuit pack.
3. Type list configuration all and press
recognizes the TN2302AP circuit packs.
Administration Steps
1. Administer the TN799B/C C-LAN. Refer to the Administration for Network
Connectivity for Avaya Communication Manager.
2. Administer the IP Media Processor, which is usually done remotely. Call
your service representative to start the process.
3. Complete the administration and testing. Refer to
Steps for C-LAN and IP Media Processor'' on page 7-56
External Connection to the LAN'' on page
7-60
Issue 7 November 2003
to verify that the system
Enter
''Initial Administration
and ''Test the
7-58.
555-233-115