Avaya DEFINITY Server R Manual page 409

Remove an EPN Cabinet from an Existing System
5. Type remove cabinet <number> and press
cabinet administration.
6. Remove the power cords from the power units in each carrier in the EPN
and remove the AC power cord or DC power wires.
7. Check the grounding scheme for the cabinets. Perform the following:
a. If any cabinet ground wires connect in series between the EPN
b. If any cabinet ground wires connect in parallel to other cabinets, or
8. Carefully remove the EPN cabinet. The cabinet may weigh as much as 800
pounds. Use caution.
9. When finished, place dust covers over all exposed fiber couplings that
remain after the fiber optic cables are removed.
10. If any fiber optic cables were removed from Lightguide Interconnect Units
(LIUs) or Fiber Patch Panels, remove the associated cable labeling. This
will prevent confusion if existing fiber is later moved.
11. Return all unused equipment (not owned by the customer) to Avaya
according to the requirements outlined in:
BCS/Material Logistics, MSL/Attended Stocking Locations
Methods and Procedures for Basic Material Returns
Troubleshooting
Message Waiting Lamps On
This usually means that all affected port-related translations were not
unadministered.
1. Type clear amw all <extension> and press
waiting lamp for the specified extension.
2. Repeat the command for each extension with a lit message waiting lamp.
555-233-115
cabinet and any other cabinet, remove the wires from the EPN
cabinet and connect them to the next cabinet in the ground plane.
!
CAUTION:
Never leave cabinets ungrounded. When a ground wire is
removed from a series-connected cabinet, the ground plane
becomes open with respect to all subsequent cabinets.
connect directly to the AC power panel ground or other approved
ground, remove the wire from each end of the ground span.
. This removes the EPN
Enter
. This clears the message
Enter
Issue 7 November 2003
6-93