Avaya DEFINITY Server R Manual page 333

Add a Control Carrier (Add Duplication)
Remove Port Carrier B
1. Behind the PPN, disconnect and remove the ICCB cable from between
carrier "B" and carrier "A." It will not be reused.
NOTE:
Note the position of the TDM/LAN cables before disconnecting them.
2. Disconnect 1 end of the TDM/LAN cable (between the "B" and "C" carriers)
from the "B" carrier (See
3. Disconnect 1 end of the TDM/LAN cable (between the "B" and "A" carriers)
from the "B" carrier (See
4. Disconnect 1 end of the 8 ground straps (between the "B" and "C" carriers)
from the "B" carrier (See
new "B" carrier.
5. Disconnect 1 end of the 8 ground straps (between the "B" and "A" carriers)
from the "B" carrier (See
new "B" carrier.
6. Disconnect the "P1" (small 9-pin) connector from the "B" carrier. Move the
cable into a position where it will not interfere with removing the carrier.
7. Behind the "B" carrier, remove the 2 screws holding the "B" carrier's rear
connector panel to the cabinet frame. These are frame ground screws.
8. In front of "B" carrier, remove the 4 screws (top 2 first) holding the "B"
carrier to the cabinet frame. Use a long-handle screwdriver or 5/16-inch
socket with a 10-inch extension.
9. Slide the carrier forward 1 to 2 inches; then, from the back, be sure that no
cables or wiring harnesses are caught on the cabinet/carrier framework.
!
CAUTION:
Cables and wiring harnesses can be damaged if they catch on the
framework and if too much pressure is applied in removing the carrier.
10. Remove the carrier by sliding it out the front of the cabinet.
555-233-115
Figure 6-8).
Figure 6-8).
Figure 6-9). These straps are reconnected to the
Figure 6-9). These straps are reconnected to the
Issue 7 November 2003
6-17