Self Download; Procedure - Avaya DEFINITY Server R Manual

Adding or Removing Cabinet Hardware
Self and C-LAN-distributed download

procedure

This section describes the procedures for either a self or C-LAN-distributed
firmware download. These procedures help you determine which method to use.
The main differences between the two methods are:
Table 7-3. Firmware Download Method Differences
C-LAN-distributed
download

Self download

The high-level steps used to perform a self- or C-LAN-distributed firmware
download are
1. ''Prepare for download'' on page 7-8
2. ''Upload image file from the Web to staging area'' on page 7-12
3. ''FTP the image file to source'' on page 7-12
4. ''Schedule a download to target(s)'' on page 7-13
5. ''Monitor download progress'' on page 7-17
6. ''Disable file system'' on page 7-19
NOTE:
If you have any trouble with this procedure, refer to
firmware downloads'' on page
Prepare for download
The following subsections contain procedures to prepare for the firmware
downloads to target circuit packs:
''Verify hardware/software requirements'' on page 7-9
''Get circuit pack information'' on page 7-10
''Set up source circuit pack's file system'' on page 7-11
7-8
Issue 7 November 2003
The source circuit pack is always a C-LAN, either
TN799DP or TN799C.
Multiple target circuit packs of the same TN code can
be scheduled for download at a time.
The source and target circuit packs are the same.
Each circuit pack must be scheduled for download
individually.
7-20.
''Troubleshooting
555-233-115