Avaya DEFINITY Server R Manual page 340

Adding New Carriers and EPN Cabinets
10. Connect the loose end of the TDM/LAN cable (between the "C" and "B"
carriers) to the pin-field block marked "TDM/LAN" on the right side of the
"B" carrier (See
connected to the "C" carrier when the old carrier was removed.
11. Connect the loose end of the TDM/LAN cable (between the "A" and "B"
carriers) to the pin-field block marked "TDM/LAN" on the left side of the "B"
carrier (See
connected to the "A" carrier when the old carrier was removed.
Table 6-2. TDM/LAN Connections
"J" Number
J58890BB L1
J58890BB L2
J58890BB L3
J58890AP
12. Install the alarm duplication cable (H600-198 G1) between carriers "B" and
"A." Connect the cable to the "ICCA" pin-field block (to the right of the
pin-field block for slot "00") of both carriers. See
"UAK" (upper) connector to carrier "B," and connect the "LAK" (lower)
connector to carrier "A."
!
CAUTION:
While installing the ICC cable connectors, be careful not to bend any
backplane pins. Double check each connection to verify that the pins
are straight.
NOTE:
With a connector in each hand, flex the wires within the cable's
sheath to form a usable C-shaped cable.
13. Install the ICCC cable (H600-182 G1) between carriers "B" and "A."
Connect the cable to the "ICCC" pin-field block (behind slot "01") of both
carriers. See
14. Install the duplication cable (WP91954 L1) between carriers "B" and "A."
Connect the cable to the "ICCD" pin-field block (behind slot "02") of both
carriers. See
NOTE:
The duplication cable's connectors are keyed to ensure proper
positioning on the pin-field block.
6-24
Issue 7 November 2003
Figure 6-11 and Table
Figure 6-11 and Table 6-2). The other end remained
Carrier Type LHS Slot
Port 21
Port 21
Port 21
Control 21
Figure 6-12.
Figure 6-12.
6-2). The other end remained
RHS Slot
02
01
01
02
Figure 6-12. Connect the
555-233-115