Avaya DEFINITY Server R Manual page 480

Adding or Removing Cabinet Hardware
2. Insert the TN802B IP Interface into the right most of the three slots you
reserved for it (see
When you plug in the TN802B IP Interface Assembly, the circuit pack starts
to boot and the LCD reads PC Boot. The circuit pack reboots
automatically, and after about 3 to 4 minutes the LCD changes to IPTRK*,
the default mode, or MEDPRO*.
If the TN802B is pre-administered at the factory, it reboots several times to
initialize to MedPro mode.
If the TN802B is not pre-administered, go to
page 7-71
NOTE:
For an initial installation, the TN802B IP Interface needs to be
administered first (see
1 0
9
8
7
6
5
4
indfmapd KLC 031299
Figure 7-12. J58890MA-1 L30 IP Interface Assembly
7-70
Issue 7 November 2003
Figure 7-12) and seat it properly.
''Administer the IP Interface'' on page
1 6
1 5
1 4
1 3
1 2
1 1
''Administration Steps'' on
7-71).
555-233-115