Avaya DEFINITY Server R Manual page 499

Add IP Solutions
3. At the command prompt, type ping 192.11.13.8 (which is the IP address of
the internal processor).
4. Type exit and press
The TN802B IP Interface is now installed in the carrier and connected to the IP
network.
Upgrading a TN802 V3 (or later) to a TN802B
(MedPro mode)
If you have a TN802 V3 (or later) IP Interface, you must either replace it with a
TN802B circuit pack or upgrade the existing TN802 circuit pack to operate in
MedPro mode. Also, to operate in the MedPro mode, the DEFINITY ECS switch
must be Release 8 or later.
NOTE:
The TN802 IP Interface must be V3 or later to upgrade to TN802B.
To upgrade the TN802 to a TN802B, you need the following hardware:
Monitor, keyboard, and mouse to access the IP Interface's Windows NT
environment or pcANYWHERE software.
10-Mbyte SanDisk PCMCIA flashcard loaded with the MedPro
NT Application Install Wizard
TN802B label
The upgrade adds or modifies the following directories or files on your computer's
hard drive:
c:\dolan\*
c:\mapd\dnld\medpro.img
c:\mapd\dnld\tmp.img
555-233-115
If you have connectivity, the system responds with the following
message:
Reply from 192.11.13.8: bytes=32 time<##ms TTL=###
If no response, verify the IP settings for Adapter [1].
.
Enter
Issue 7 November 2003
7-89