Avaya DEFINITY Server R Manual page 427

Upgrade Firmware on Programmable Circuit Packs
3. Press
If you set the Schedule Download field to n, the download starts as soon
as you submit the schedule.
NOTE:
If you are scheduling firmware downloads for a circuit pack that is
designated as primary/secondary sync (timing) source (for example,
TN464GP), this procedure automatically redesignates a local timing source
during the download. After the download is complete and the circuit pack is
returned to service, the procedure designates the original circuit pack as the
timing source.
NOTE:
The target circuit packs are automatically removed from service while the
firmware is downloaded to them and automatically returned to service after
the download is completed. While a circuit pack is removed from service,
any active calls through that circuit pack are dropped.
NOTE:
An error message asking you to use the command, test firmware
download, means that there was a problem with a previous firmware
download. Run the test before proceeding. Go to
download'' on page
!
CAUTION:
Unless the Remove Image File After Successful Download field
is set to y, the ftplogin and ftppassword remain on the TN799DP or TN799C
(C-LAN) and TN2501AP (VAL) circuit packs either until they are reset or until
you type the disable filesystem board UUCSS command.
4. If the download is scheduled for later, ensure that the download will run as
you intend by testing the firmware download. Go to
download'' on page
Monitor download progress
You can check the progress of a firmware download with this procedure.
1. Type status firmware download and press
Firmware Download screen.
555-233-115
to submit the schedule.
Enter
7-20.
7-20.
''Testing firmware
''Testing firmware
to display the Status
Enter
Issue 7 November 2003
7-17