Avaya DEFINITY Server R Manual page 469

Add IP Solutions
Upgrading TN802 IP Trunking to TN2302AP IP
Media Processor
To upgrade IP Trunking to IP Media Processor, you must replace
The TN802 circuit pack with a TN2302AP circuit pack
The TN799 circuit pack with a TN799B/C circuit pack
The H600 512, G1 external cable assembly with an IP Media Processor
adapter.
Pre-upgrade steps
1. Type list configuration all and press
pack ports.
2. Type display port UUCSSppp and press
number associated with the TN802 circuit pack port.
3. Type change trunk-group number and press
all the TN802 ports.
4. Repeat steps1 through 3 for each port.
5. Type remove ds1 UUCSS and press
Remove the Circuit Packs
!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against
electrostatic discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799B/C, TN802, and TN2302AP circuit packs are hot-swappable, so
you do not need to power down the carrier to remove or install them.
1. Press the recessed Reset button on the TN802 circuit pack until MSHUT*
starts flashing on the LCD. When MSHUT* is in a steady state, it is safe to
remove the circuit pack.
2. Remove the TN799 and TN802 circuit packs.
Replace the Cables
1. Disconnect the network cable from the Ethernet connection.
2. If using a monitor, keyboard, and mouse:
a. Turn off the monitor and unplug it from the AC outlet.
b. Disconnect the monitor, keyboard, and mouse from the H600-512
3. Turn off the modem and unplug it from the AC outlet.
555-233-115
external cable assembly.
to locate all the TN802 circuit
Enter
to find the trunk group
Enter
. Go to screen 4. Delete
Enter
.
Enter
Issue 7 November 2003
7-59