Avaya DEFINITY Server R Manual page 432

Adding or Removing Cabinet Hardware
4. Type set boot-image board UUCSS image 1 | 2 and press
Example: set boot-image board 1C07 image 2
The system responds with Command Successfully Completed.
5. Type get boot-image UUCSS and press
firmware images on the target circuit pack.
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 03/02/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: No
Note that the values in the Reboot Image field have changed.
NOTE:
If a TN799C/DP C-LAN or TN2305 VAL circuit pack, reseat them to activate
the new firmware image. Go to
6. Type get boot-image UUCSS to check the status of the firmware images
on the target circuit pack.
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 03/02/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: No
Reboot Image: No
7. Ensure that both the Active Image and the Reboot Image fields are as
you expect.
7-22
Issue 7 November 2003
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
03/02/01
12:42:18
Good
No
Yes
''Reseat VAL circuit pack'' on page
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
03/02/01
12:42:18
Good
Yes
Yes
.
Enter
to check the status of the
Enter
555-233-115
7-19.