Avaya DEFINITY Server R Manual page 165

Interconnect Port Networks with Fiber Optic Cabling
For a standard reliability system with 2 fiber-remoted EPNs, use 6 fiber optic
cables, 6 lightwave transceivers, and 6 lightguide interface units (provided by the
PSC).
DS1 CONV-Remoted Port Networks
For a standard reliability system with 1 DS1 CONV-remoted EPN, use 2 DS1
CONV circuit packs (TN1654), 2 DS1 Conv-to-EI cables (846448637 and/or
846448645), two H-600-348 cables, from 1 to 4 pairs of Channel Service Units
(CSUs), and from 1 to 4 pairs of MDF cables (provided with the CSUs).
NOTE:
The TN1654 requires the use of a TN573B Switched Node Interface circuit
pack
For a standard reliability system with 2 DS1 CONV-remoted EPNs, this
arrangement requires:
6 DS1 CONV circuit packs (TN1654)
6 DS1 CONV-to-EI cables (846448637 and/or 846448645)
6 H600-348 cables
3, 6, 9, or 12 pairs of CSUs
3, 6, 9, or 12 pairs of wall-field cables (provided with CSUs)
5, 10, or 15 dB attenuators (single-mode fiber only)
5-dB Attenuator
10-dB Attenuator
15-dB Attenuator
For 1 or 2 Collocated Expansion Port Networks
1. Behind port carrier B of the multicarrier PPN. See
4-10:
a. Install a lightwave transceiver on the connector at slot 1B02.
b. Connect 1 end of the appropriate fiber optic cable to the lightwave
c. Route the fiber optic cable from the lightwave transceiver to the
d. Carefully attach the fiber optic cable (with cable ties) to the wall of
555-233-115
106060718
106060734
106061021
NOTE:
Attenuators may be required for single mode fiber using a
300A Lightwave Transceiver
transceiver at slot 1B02.
cabinet's cable tray and down out of the cabinet to the EPN stack.
the cable tray at the built-in cable tie positions.
Figure 4-9 and Figure
Issue 7 November 2003
4-41