Avaya DEFINITY Server R Manual page 486

Adding or Removing Cabinet Hardware
Connect the Cables
1. Determine into which port slot you are putting the TN802B IP Interface.
NOTE:
Make sure that at least 3 adjoining slots are free.
2. From the rear of the cabinet, connect the amphenol connector on the
external cable assembly to the backplane connector corresponding to that
slot (the highest numbered connector of the 3 slots required).
Connect the Modem
NOTE:
These instructions are for connecting the U.S. Robotics modem supplied to
U.S. customers only. If using a different modem, follow the manufacturer's
instructions on connecting the modem.
1. Connect the RS232 port of the modem to the MODEM connector of the
TN802B external cable assembly.
NOTE:
Check the labels near the connectors; the MODEM and COM2
connectors look the same.
2. Connect an analog telephone line to the leftmost analog-line port on the
modem as shown in
3. Make sure that the modem's DIP switches are set as shown in
Figure 7-14
4. Plug the modem into an AC power outlet.
5. Turn on the modem using the switch on the front of the modem.
7-76
Issue 7 November 2003
Figure 7-14.
and Table 7-14.
555-233-115