Avaya DEFINITY Server R Manual page 171

Interconnect Port Networks with Fiber Optic Cabling
For 2 Collocated Expansion Port Networks
1. Behind port carrier D of the multicarrier PPN:
a. Install a lightwave transceiver on the connector at slot 1D02.
b. Connect 1 end of the appropriate fiber optic cable to the lightwave
c. Route the cable to the cabinet's cable tray and down, out of the
d. Carefully attach the fiber optic cable (with cable ties) to the wall of
2. Behind control cabinet A of EPN stack 3:
a. Install a lightwave transceiver on the connector at slot 3A01.
b. Connect the other end of the fiber optic cable from the PPN to the
c. Carefully attach the fiber optic cable (with cable ties) to the rear
d. Coil the surplus fiber optic cable and place it either in the cable
3. Behind control cabinet A of EPN stack 2:
a. Install a lightwave transceiver on the connector at slot 2A02.
b. Connect a fiber optic cable to the transceiver just installed.
c. Route the cable down the outside of the rear covers to the other
d. Carefully attach the fiber optic cable (with cable ties) to the rear
555-233-115
NOTE:
Attenuators may be required for single mode fiber using a
300A Lightwave Transceiver
transceiver at slot 1D02.
cabinet, to the EPN stack.
the cable tray at the built-in cable tie positions.
NOTE:
Attenuators may be required for single mode fiber using a
300A Lightwave Transceiver
lightwave transceiver at slot 3A01.
covers of the EPN stack.
manager or on the bottom shelf (holding the power supply) of the
PPN cabinet.
NOTE:
Attenuators may be required for single mode fiber using a
300A Lightwave Transceiver
EPN stack.
covers of the EPN stack.
Issue 7 November 2003
4-47