Table of Contents
Advertisement
Table 4-2
NOTE
Setup Data Area
The Setup Data 1 and Setup Data 2 areas display the source output setting, the
source compliance setting, the measurement range setting, or the error code. The
display item can be selected by the MON_ITEM menu, displayed by pressing the
key. The item for the Setup Data 1 area can be specified by the ITEM1
Menu
parameter, and the item for the Setup Data 2 area can be specified by the ITEM2
parameter.
Table 4-2
shows the display format in the setup data area.
Setup Data Area
Display Example
OUT:-123.4mV
CPL:-12.34mA
VMR: 2V
IMR: 10uA
ERR: No Err
a. A pulse source is available for the pulsed spot measurement, pulsed
sweep measurement, staircase sweep with pulsed bias measurement, or
quasi- pulsed spot measurement when the E5260/E5270 is in the remote
condition.
If you press the
OUT Value
•
Setup Data 1: OUT (source output setting)
•
Setup Data 2: CPL (source compliance setting)
Then, press the
or
Exit
Enter
Keysight E5260/E5270 User's Guide, Edition 6
Description
Source output setting. Four-digit numeric value with
arithmetic point, and unit.
Pulse base value will be displayed for the pulse source.
Source compliance setting. Four-digit numeric value with
arithmetic point, and unit.
Range value used for the voltage measurement.
Available range values depend on the module.
Range value used for the current measurement.
Available range values depend on the module.
where uA means μA.
Error code.
or
key, this area displays the following items:
CPL Value
key to return to the previous items.
Front Panel Reference
Display and Front Panel Keys
a
4-7
Advertisement
Table of Contents
