Canon imageRUNNER ADVANCE C5560i III User Manual page 1086

Hide thumbs Also See for imageRUNNER ADVANCE C5560i III:

Table of Contents

This section describes the copy and print finishing settings, such as adjusting the saddle stitch position.

Feeds papers to the saddle stitcher unit and staples them several times, and performs the saddle stitch staple

repositioning procedure. The machine performs this adjustment procedure if stapling has not been performed

after you clear a staple jam or replace the staple cartridge.

When performing repositioning, note the following.

Make sure to load plain paper.

Remove any output paper from the booklet tray.

Paper that is required for the saddle stitch staple repositioning procedure is automatically fed to the

saddle stitcher unit by the machine.

305 mm x 457 mm, A3, B4, A4R, 11" x 17", LGL, LTRR, or custom paper sizes equivalent to these paper

sizes can be used. (Make the paper source to which transparencies are registered unavailable.)

This mode can be set when the Booklet Finisher-Y is attached.

If you notice that the saddle stitch position of the paper is not exactly in the middle of the booklet, you can

make adjustments to the saddle stitch position to compensate for this error. Adjust the folding position of the

paper and the saddle stitch position at the same time.

If you notice that the folds of the paper are not exactly in the middle of the booklet, you can make adjustments

to the fold placement to compensate for this error. This mode enables you to adjust the folding position without

changing the stapling position.

You can set whether to give priority to the punching speed or to precision.

Settings/Registration

Adjusting the Saddle Stitch Position(P. 1214)

Adjusting the Saddle Stitch Folding Position(P. 1215)

Chapters

Table of Contents