Canon imageRUNNER ADVANCE C5560i III User Manual page 1120

● If this setting is set to <Off>, the user name in <00> is used as the default setting for the sender name.
For instructions on registering a user name, see
<ECM TX>
<Function Settings>
You can set whether to use ECM in the fax transmission protocol. ECM checks for fax data errors and corrects
them.
● If the communication speed appears to be extremely slow, you may be able to improve the speed by
setting to <Off>.
● Even when you set ECM, errors can sometimes occur due to a poor telephone line connection.
● The conditions for successful ECM transmission are indicated below.
- ECM transmission is enabled with this setting
- The destination supports ECM
- <ECM TX> was set to <On> when registering the destination address to the Address Book
Registering Destinations in the Address Book(P. 223)
<Set Pause Time>
<Function Settings>
You can set the number of seconds to pause when sending faxes. Some overseas dialing may not be successful
when dialing the international access code, country code, and the destination's telephone number all at once. In
such cases, inserting a pause after the international access code can make it easier to connect.
● Pauses entered at the end of dialed fax numbers are always 10 seconds long.
<Auto Redial>
<Function Settings>
Auto Redial enables the machine to automatically redial the recipient's fax number if the recipient cannot be
reached due to a busy line, or if a sending error occurs. If you activate this setting, you can set how many times
the machine redials, the redial interval, and whether the document should be resent when there is an error.
<Check Dial Tone Before Sending>
<Function Settings>
If you are sending a fax from your machine at the same time another fax machine (made by a company other
than Canon) is trying to send you a fax, your fax may end up being redirected to that fax machine, instead of
the original destination you had intended. Activating this setting enables you to avoid such sending problems.
Settings/Registration
<Send> <Fax Settings>
<Send> <Fax Settings>
<Send> <Fax Settings>
<Send> <Fax Settings>
1106
Fax Line Settings(P. 72) .