Canon imageRUNNER ADVANCE C5560i III User Manual page 759

<All IPv4 Addresses>
<All IPv6 Addresses>
<IPv4 Manual Settings>
<IPv6 Manual Settings>
3
Specify the port to apply IPSec to.
● Press <Specify by Port Number> to use port numbers when specifying the ports that IPSec applies to.
Select <All Ports> to apply IPSec to all port numbers. To apply IPSec to a specific port number, press
<Single Port> and enter the port number. After specifying the ports, press <OK>. Specify the port of
this machine in <Local Port>, and specify the port of the communication peer in <Remote Port>.
● Press <Specify by Service Name> to use service names when specifying the ports that IPSec applies to.
Select the service in the list, press <Service On/Off> to set it to <On>, and press <OK>.
4
Press <OK>.
6
Configure the authentication and encryption settings.
1
Press <IKE Settings>.
2
Configure the necessary settings.
Managing the Machine
IPSec is applied to IP packets sent to and received from the IPv4 address of the
communication peer.
IPSec is applied to IP packets sent to and received from the IPv6 address of the
communication peer.
Specify the IPv4 address to apply IPSec to.
● Select <Single Address> to enter an individual IPv4 address.
● Select <Address Range> to specify a range of IPv4 addresses. Enter a separate
address for <First Address> and <Last Address>.
● Select <Subnet Settings> to specify a range of IPv4 addresses using a subnet
mask. Enter separate values for <Address> and <Subnet Mask>.
Specify the IPv6 address to apply IPSec to.
● Select <Single Address> to enter an individual IPv6 address.
● Select <Address Range> to specify a range of IPv6 addresses. Enter a separate
address for <First Address> and <Last Address>.
● Select <Specify Prefix> to specify a range of IPv6 addresses using a prefix. Enter
separate values for <Address> and <Prefix Length>.
745