●
Making punch holes in the top margin area of paper in landscape orientation
When Placing A4-, B5-, A5-size Originals
Feeder
●
For information on the paper sizes that can be used for Staple and Hole Punch, see
H(P. 1503) .
●
To replace the staple cartridge of the stapler unit, see
●
For how to clear a paper jam or a staple jam, see
Jams (Optional)(P. 1367) .
●
The maximum number of bindable sheets may not be possible, depending on the paper type. In this case,
change the paper type, or reduce the number of sheets to bind.
Collate and group
●
If you select <Offset> in combination with the collate or group function, each printout group is shifted.
Staplers
●
When you are using the Staple mode, do not remove the stack of paper from the output tray during the job.
Remove the stack of paper when the job has been completed.
●
If the <Load staples into the stapler unit.> message appears, almost all of the staples have been used. To
proceed, replace the staple cartridge.
●
Output temporarily stops when the tray reaches the lowest position or when 30 sets have been stapled.
Printing resumes when you remove all of the paper that has been output.
Appendix
Platen glass
Loading Staples (Optional)(P. 1176) .
Clearing Paper Jams(P. 1337) and
1555
Inner Finisher-
Clearing Staple