Canon imageRUNNER ADVANCE C5560i III User Manual page 1304

A competing IP address was found on the network.
The IPv4 address set for the machine already exists in the same network as the machine.
● Change the IP address of the machine in <IP Address> in <IPv4 Settings> so that it does not conflict with
the IP address of another device.
Setting an IPv4 Address(P. 37)
An IP address conflict was detected on the network (Main Line).
The IPv4 address set for the main line of the machine already exists on the same network as the
machine.
● Change the IP address of the main line of the machine so that it does not conflict with the IP address of
another device.
Setting an IPv4 Address(P. 37)
An IP address conflict was detected on the network (Sub Line).
The IPv4 address set for the sub line of the machine already exists on the same network as the machine.
● Change the IP address of the sub line of the machine so that it does not conflict with the IP address of
another device.
Setting the IPv4 Address of the Sub Line(P. 42)
Could not perform the operation because a network error occurred.
Writing from an external source is not allowed.
● Set <Prohibit Writing from External> for the destination to <Off>.
You tried to save a file directly under a shared space or personal space.
● Files cannot be saved directly under the shared space (share) or personal space (users) of an Advanced
Box. Select a folder in the space and save the file.
The full path (the folder name indicating the filename and destination to save) is too long.
● Shorten the folder name or file name or change the destination to save so that the number of characters
for the path is 256 characters or fewer, including "/share" or "users".
The file cannot be stored because the maximum number of files/folders has been exceeded.
● Delete unnecessary files so that the number of files is fewer than the maximum of 100,000 for an
Advanced Box, and 1,000 for a single folder. Alternatively, change the destination.
The hard disk space is insufficient for storing the file.
● Delete unnecessary files or change the destination.
Check the network connection.
The cable is not connected to the machine correctly.
● Check whether the LAN cable is connected correctly. If you had to connect it again, restart the machine.
Connecting to a Wired LAN(P. 27)
The machine is not connected to the network.
● If you want to use the machine without connecting to a network, set <Confirm Network Connection
Setting Changes> to <Off>.
Troubleshooting
1290