3.4
Control Unit installation
The Control Unit is snapped
onto the Power Module as
shown in the figure. To dis-
connect the CU push the
release button on top of the
PM.
The process of fitting the
Control Unit onto the Power
Module is the same tech-
nique independent of the
type of Control Unit or Power
Module.
3.5
Installing supplementary components
A line filter or n output reactor may be required depending on the particular application.
Additional information about mounting these components is provided in the instructions
supplied.
Power Module PM230, IP20 / Push-through technology (PT)
Hardware Installation Manual, 06/2014, A5E34331322B AA
Fitting the Control Unit onto the Power Module
Installing/mounting
3.4 Control Unit installation
27