Figure 5-1 Connecting The Esi Using Twisted 2-Pair Cable; Table 5-4 Electra Elite/Dterm Series E Multiline Terminal Loop Resistance And Cable Length; Table 5-5 Cable Connection Between The Analog Port And The Single Line Equipment; Table 5-6 Cabling Requirements - NEC Electra Elite IPK II General Description Manual

Document Revision 1
C
S 3
ABLING
ECTION
This section provides cabling requirements and specifications for various equipment
used in the Electra Elite IPK II system.

Figure 5-1 Connecting the ESI Using Twisted 2-Pair Cable

KSU connected with each of the Multiline Terminals and Single Line Telephones by a
separate twisted 1-pair cable or 2-pair cable (only for Multiline Terminals).
Refer to the following tables for cabling requirements and specifications.
J
J
J
J
5 - 2
R
EQUIREMENTS AND
ESI
Figure 5-1 Connecting the ESI Using Twisted 2-Pair Cable
term
Table 5-3 D Series i or D
Table 5-4 Electra Elite/Dterm Series E Multiline Terminal Loop Resistance and
Cable Length
Table 5-5 Cable Connection Between the Analog Port and the Single Line
Equipment

Table 5-6 Cabling Requirements

S
PECIFICATIONS
Twisted 2-Pair Cable
term
IP Terminal Loop Resistance and Cable Length
Electra Elite IPK II
provides a diagram of the
RJ-11
Multiline Terminal
Hardware Specifications