Application Warning Messages - ABB ACS880 Firmware Manual

586 Fault tracing

Application warning messages

Code
Warning
(hex)
E200 Web Loss
1
2
E210 Invalid Diameter
Settings
1
E299 Simulation Mode
Cause
The processed material (web,
wire or cable) may be broken.
Speed error detected by speed
error watchdog is below the
tripping level set with
parameter 81.04 Speed error
low %.
Tension or dancer feedback
signal is below the tripping
level set with parameter
Speed error low %.
Some diameter settings need
to be corrected.
76.09 Full roll diameter
than 76.08 Core diameter.
Simulation mode is active.
What to do
If the material is not broken, check the
settings of parameter group
safety.
Check the event log for an auxiliary code.
See appropriate actions for each code
below.
If the material is not broken, increase the
tripping delay (parameter
loop trip delay) and raise the speed
additive (parameters
ref offset and 75.32 Dynamic offset
If the material is not broken, check the
settings of parameter group
81.04 safety.
Especially check the parameter
Speed error low %
Verify the settings of parameter group
Diameter calculation.
Check the event log for an auxiliary code.
See appropriate actions for each code
below.
is less Set valid diameter values for parameters
76.08 Core diameter
diameter.
Take a note of that. Only passive load
tests are allowed in simulation mode, so
never run a machine with a real material
in tension if this alarm is active.
81 Winder
81.09 Open-
75.31 Overspeed
trim).
81 Winder
81.04
for too high value.
76
and 76.09 Full roll