ABB ACS880 Firmware Manual page 479

No. Name/Value
95.15 Special HW settings
Bit Name
0 EX motor
1 ABB sine filter
2 High speed mode
3 Custom sine filter
4...15 Reserved
0000b...0111b
Description
Contains hardware-related settings that can be enabled and
disabled by toggling the specific bits.
Note: The installation of the hardware specified by this
parameter may require derating of drive output, or impose
other limitations. Refer to the hardware manual of the drive.
Description
1 = The driven motor is an Ex motor provided by ABB for
potentially explosive atmospheres. This sets the required
minimum switching frequency for ABB Ex motors. Note: For non-
ABB Ex motors, contact your local ABB representative.
1 = An ABB sine filter is connected to the output of the
drive/inverter.
1 = Minimum switching frequency limit adaptation to output
frequency active. This setting improves control performance at
high output frequencies (typically above 120 Hz).
1 = A custom sine filter is connected to the output of the
drive/inverter. See also parameters 97.01, 97.02, 99.18, 99.19.
Hardware options configuration word.
Parameters 479
Def/FbEq16
-
1 = 1