ABB ACS880 Firmware Manual page 17

Term/abbreviation
FENA-21
FEPL-02
FIO-01
FIO-11
FPBA-01
FPTC-01
FPTC-02
FSCA-01
FSO-xx
HTL
ID run
IGBT
INU-LSU
Inverter unit
I/O
ISU
Line-side converter
LSU
ModuleBus
Motor-side converter See
Network control
Parameter
PID controller
Definition
Optional dual-port Ethernet/IP, Modbus/TCP and PROFINET IO
adapter
Optional POWERLINK adapter
Optional digital I/O extension module
Optional analog I/O extension module
Optional PROFIBUS DP adapter
Optional temperature measurement module. Not released for sales at
the time of publication.
Optional temperature measurement module for potentially explosive
atmospheres. Not released for sales at the time of publication.
Optional Modbus/RTU adapter
Optional safety functions module
High-threshold logic
Motor identification run. During the identification run, the drive will
identify the characteristics of the motor for optimum motor control.
Insulated gate bipolar transistor; a voltage-controlled semiconductor
type widely used in inverters and IGBT supply units due to their easy
controllability and high switching frequency
Type of optical DDCS
example the supply unit
The part of the drive that converts DC to AC for the motor.
Input/Output
An IGBT supply unit; type of supply unit implemented using IGBT
switching components, used in regenerative and low-harmonic drives.
See supply unit.
See supply unit.
A communication link used by, for example, ABB controllers. ACS880
drives can be connected to the optical ModuleBus link of the controller.
inverter unit.
With fieldbus protocols based on the Common Industrial Protocol
TM
(CIP ), such as DeviceNet and Ethernet/IP, denotes the control of the
drive using the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive
Profile. For more information, see www.odva.org, and the following
manuals:
• FDNA-01 DeviceNet adapter module User's manual
(3AFE68573360 [English]), and
• FENA-01/-11 Ethernet adapter module User's manual
(3AUA0000093568 [English]).
User-adjustable operation instruction to the drive, or signal measured
or calculated by the drive
Proportional–integral–derivative controller. Drive speed control is
based on PID algorithm.
Introduction to the manual 17
communication link between two converters, for
and the inverter unit of a drive system.