ABB ACS880 Firmware Manual page 466

466 Parameters
No. Name/Value
91.06 Module 2
temperature
0...1000 °C, °F or
ohm
91.10 Encoder parameter
refresh
Done
Refresh
91.11 Module 1 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.12 Module 1 location
Slot 1
Slot 2
Slot 3
4...254
91.13 Module 2 type
None
FEN-01
FEN-11
FEN-21
FEN-31
FSE-31
91.14 Module 2 location
Slot 1
Slot 2
Description
Displays the temperature measured through the sensor
input of interface module 2. The unit is selected by
parameter 96.16 Unit selection.
Note: With a PTC sensor, the unit is ohms.
This parameter is read-only.
Temperature measured through interface module 2.
Validates any changed encoder interface module
parameters. This is needed for any parameter changes in
groups 90...93 to take effect.
After refreshing, the value reverts automatically to Done.
Notes:
• Permanent magnet motors only: The drive will perform a
fresh autophasing routine (see page 100) at next start if
the motor feedback encoder settings have been changed.
• The parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Defines the type of the module used as interface module 1.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
Reserved.
Specifies the slots 1...3 on the control unit of the drive into
which the interface module is installed. Alternatively,
specifies the node ID of the slot on an FEA-03 extension
adapter.
Slot 1.
Slot 2.
Slot 3.
Node ID of the slot on the FEA-03 extension adapter.
Defines the type of the module used as interface module 2.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
Reserved.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed. Alternatively,
specifies the node ID of the slot on an FEA-03 extension
adapter.
Slot 1.
Slot 2.
Def/FbEq16
-
-
Done
0
1
None
0
1
2
3
4
5
Slot 2
1
2
3
1 = 1
None
0
1
2
3
4
5
Slot 3
1
2