ABB ACS880 Firmware Manual page 238

238 Parameters
No. Name/Value
EFB MCW bit 3
DIIL
Active control
source MCW bit 3
Other [bit]
20.19 Enable start
command
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
DIIL
Other [bit]
Description
Control word bit 3 received through the embedded fieldbus
interface.
DIIL input (10.02 DI delayed
Control word bit 3 received from the active control source. In
case the active source is the control panel, PC tool or drive
I/O, the run enable signal is always on.
Note: If the drive is running, switching bit 3 off effectively
removes both the start and run enable signals. In this case,
the stop mode is determined by either
stop mode or 21.03 Stop
priority. The order of stop modes from highest to lowest
priority is Coast – Torque limit
Source selection (see Terms and abbreviations
page 152).
Selects the source for the start enable signal.
1 = Start enable.
With the signal switched off, any drive start command is
inhibited. (Switching the signal off while the drive is running
will not stop the drive.)
Notes:
• If a level-triggered start command is on when the start
enable signal switches on, the drive will start. (An edge-
triggered start signal must be cycled for the drive to start.)
See parameters 20.02 Ext1 start trigger
start trigger type and
• The warning that indicates a missing signal can be
suppressed using parameter
warning function.
See also parameter 20.12 Run enable 1
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
DIIL input (10.02 DI delayed
Source selection (see Terms and abbreviations
page 152).
status, bit 15).
20.11 Run enable
mode, whichever mode has higher
– Ramp.
on
type,
20.29 Local start trigger
20.30 Enable signals
source.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
status, bit 15).
on
Def/FbEq16
32
33
34
-
Selected
20.07 Ext2
type.
0
1
2
3
4
5
6
7
10
11
30
-